Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NRZ/NRZI encoding on channelized E1

Is it possible to configure NRZ or NRZI encoding on serial-line subinterfaces with a channelized E1 connection (NM-1CE1B)?

Thanks in advance.

Daniel Ruch

  • Other Network Infrastructure Subjects
1 REPLY
New Member

Re: NRZ/NRZI encoding on channelized E1

No, you can not configure the encoding parameters at the serial interface. You can configure all the encoding (hdb3) in case of E1 only at the controller level.

http://www.cisco.com/en/US/products/hw/routers/ps1904/products_command_reference_chapter09186a008007dbd4.html#xtocid325940

397
Views
0
Helpful
1
Replies