cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
392
Views
0
Helpful
1
Replies

NSS326 Smart Storage Raid rebuild stuck at 0%

bcsmith
Level 1
Level 1

We have a Cisco NSS326 v01 Smart Storage NAS unit that recently had a failing drive.  We replaced the drive recently, and the RAID 5 array has been stuck at "rebuilding: 0%" for days now.  The replaced drive shows up just fine in the gui, with a "good" status.  All the logs indicate no issues.  Not sure where to go with this...  Warranty is no longer valid, and cannot open a TAC case.  Any assistance would be greatly appreciated.  

1 Reply 1

Philip D'Ath
VIP Alumni
VIP Alumni

I would be tempted to try removing the new drive and putting it back in, to try and tempt the rebuild to start.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: