Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

NSS326 Smart Storage Raid rebuild stuck at 0%

We have a Cisco NSS326 v01 Smart Storage NAS unit that recently had a failing drive.  We replaced the drive recently, and the RAID 5 array has been stuck at "rebuilding: 0%" for days now.  The replaced drive shows up just fine in the gui, with a "good" status.  All the logs indicate no issues.  Not sure where to go with this...  Warranty is no longer valid, and cannot open a TAC case.  Any assistance would be greatly appreciated.  

Everyone's tags (1)
1 REPLY
VIP Purple

I would be tempted to try

I would be tempted to try removing the new drive and putting it back in, to try and tempt the rebuild to start.

88
Views
0
Helpful
1
Replies
CreatePlease to create content