Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NT router

hello to all

Hi iam facing apeculiar problem. I ahve to connect to remote server thru tcp/ip thru a routed network of cisco routers (onlyeigrp).

However the first hop in th route is also an NT server router which has only RIP enabled. how to enable IP helper address or is there any alternative that can be done to enable Routing.

4 REPLIES
New Member

Re: NT router

You can enable RIP on the router that connects to the NT server and redistribute EIGRP into RIP. You may need to redistribute RIP back into EIGRP if the NT server is aware of routes that the router doesn't have.

Mick.

New Member

Re: NT router

Thank u

Can any thing be just done on the NT router?

New Member

Re: NT router

You can add persistant static routes on the NT box.

New Member

Re: NT router

N/W x.x.x.x--------------NT Box------------------N/W y.y.y.yCiscobox1>>>>>>>CiscoBox2+Set of Cisco Boxes---------NTServerA

I have added one persistent route on the the Nt box

Iam not able to ping the NT serverA . Also trace route works upto Nt server after which dies out.From N/W y.y.y.y Iam able to ping NT serverA.

231
Views
0
Helpful
4
Replies