I think that there are no full NTP implementations for the Windows platforms. Windows uses W32time which is actually a SNTP implementations which is not as robust and does not contain all the error checking and control of a full RFC compliant NTP server. You will not be able to get most routers to synch with a Windows based SNTP server. The only routers that can run SNTP
are the 800, 1000, 1600 and 1700. Most of the Catalyst switches also run SNTP and can synch to the Windows SNTP servers. In order to synch the routers, you can use the following source:: NTP public server on the internet.
Certain low-end Cisco devices only support SNTP. SNTP is a simplified, client-only version of NTP. SNTP can only receive the time from NTP servers and cannot be used to provide time services to other systems. SNTP typically provides time within 100 milliseconds of the accurate time. In addition, SNTP does not authenticate traffic, although you can configure extended access lists to provide some protection. An SNTP client is more vulnerable to misbehaving servers than an NTP client and should
only be used in situations where strong authentication is not required
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...