I would like to configure NTP on my network to sychronize all my CCM, router, switches, servers and workstations.
I had been thinking about using my Gateway to acomplish this task. It will be the NTP server pointing to an external source and everybody else will synchronize from there. I do have a couple of questions:
1. Do I need to configure QoS? I have read a couple of documents where they specify that.
2. Would the synchronization affect my telephony network?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...