03-11-2003 02:01 AM - edited 03-02-2019 05:45 AM
Hi All,
a silly question....
What is the command to set the number of line displayed when you type a SHOW COMMAND.
I have to take the show tech from some routers and I need to have the show output in just one go.
I have used this command before, but I do not remember.
Thanks
Matteo
Solved! Go to Solution.
03-11-2003 03:56 AM
Hi Matteo
If i understand you correct you mean the "terminal lenght (#of lines)" command.
If you make a "terminal lenght 0" and then lets say give a "show running-config" it shows you the whole config at ones.
Hope that helps you
Roger
03-11-2003 03:56 AM
Hi Matteo
If i understand you correct you mean the "terminal lenght (#of lines)" command.
If you make a "terminal lenght 0" and then lets say give a "show running-config" it shows you the whole config at ones.
Hope that helps you
Roger
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: