Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
Cisco Employee

Number of line in SHOW COMMAND

Hi All,

a silly question....

What is the command to set the number of line displayed when you type a SHOW COMMAND.

I have to take the show tech from some routers and I need to have the show output in just one go.

I have used this command before, but I do not remember.

Thanks

Matteo

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Number of line in SHOW COMMAND

Hi Matteo

If i understand you correct you mean the "terminal lenght (#of lines)" command.

If you make a "terminal lenght 0" and then lets say give a "show running-config" it shows you the whole config at ones.

Hope that helps you

Roger

1 REPLY
Bronze

Re: Number of line in SHOW COMMAND

Hi Matteo

If i understand you correct you mean the "terminal lenght (#of lines)" command.

If you make a "terminal lenght 0" and then lets say give a "show running-config" it shows you the whole config at ones.

Hope that helps you

Roger

77
Views
0
Helpful
1
Replies
CreatePlease to create content