Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ODR and Frame Relay

1.Does ODR supported on Frame-relay network ?

2. Can we enable Dial-Backup at spoke router in ODR implimentation?

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: ODR and Frame Relay

1. ODR is supported by any medium that supports CDP, including frame relay.

2. You can enable dial-backup at an ODR-enabled spoke router. You must set up the primary interface with a backup interface. Floating statics will not be an option for your dial-backup scheme since, with ODR, the spoke router receives no routing information over the primary link.

Hope this helps.

Mark

2 REPLIES
Bronze

Re: ODR and Frame Relay

1. ODR is supported by any medium that supports CDP, including frame relay.

2. You can enable dial-backup at an ODR-enabled spoke router. You must set up the primary interface with a backup interface. Floating statics will not be an option for your dial-backup scheme since, with ODR, the spoke router receives no routing information over the primary link.

Hope this helps.

Mark

New Member

Re: ODR and Frame Relay

If the medium is Frame Relay, we may not be able to use backup interfaces

since even if the PVC is down, the physical interface may be not down.

106
Views
0
Helpful
2
Replies
CreatePlease to create content