Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

OIR fault

The following message is spuriously appearing on the command line of a Cisco3640 we are using. It is populated with 1 2FE card and 3 NM4T cards. The router has hung but i can find no reason for this - any help appreciated.

%OIRINT: OIR Event has occurred oir_ctrl 1000 oir_stat F00

4 REPLIES
VIP Purple

Re: OIR fault

Hello,

the reason might be a mis-seated network module; since you have several of them, you might want to try to reseat them. There could also be a power supply problem and could indicate a power supply voltage drop.

Check out this document for more info:

http://www.cisco.com/en/US/partner/products/hw/routers/ps274/products_tech_note09186a0080109510.shtml

Regards,

Georg

New Member

Re: OIR fault

Thanks for that Georg, however i am unable to get the link to work. How can i check the power supply.

Cheers

Barry

VIP Purple

Re: OIR fault

Hello,

you can see some details on the power supply by issuing the show environment command. If you post your email address I send you the link as a saved file.

Regards,

Georg

New Member

Re: OIR fault

Thanks again, email is bhowieson@scotamb.co.uk

209
Views
0
Helpful
4
Replies