Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

OLD-CISCO-CHASSIS-MIB variable cardOperStatus

Hello,

On CATOS switches we use the CISCO-STACK-MIB variable moduleStatus as follows, this works fine :

plato> snmpwalk -m CISCO-STACK-MIB -v 2c cat102 'mialaz&' moduleStatus

enterprises.cisco.workgroup.ciscoStackMIB.moduleGrp.moduleTable.moduleEntry.moduleStatus.1

= ok(2)

On an IOS(Cat4K) switch there is no CISCO-STACK-MIB support instead we use OLD-CISCO-CHASSIS-MIB with variable cardOperStatus , this does not work :

% snmpwalk -m OLD-CISCO-CHASSIS-MIB -v 2c cat211 'mialaz&' cardOperStatus

enterprises.cisco.temporary.chassis.cardTable.cardTableEntry.cardOperStatus

= No Such Instance currently exists

How can we read the module status on an IOS based switch?

Thanks.

  • Other Network Infrastructure Subjects
2 REPLIES
Blue

Re: OLD-CISCO-CHASSIS-MIB variable cardOperStatus

Cat4K runnung IOS does not support OLD-CISCO-CHASSIS-MIB: ftp://ftp.cisco.com/pub/mibs/supportlists/cat4000/cat4000-supportlist.html

Use ENTITY-MIB instead

Re: OLD-CISCO-CHASSIS-MIB variable cardOperStatus

Entity MIB only provides information about the inventory information such as serialnumber, name, description to name a few. However cardOperStatus cannot be had from Entity-MIB.

Is there any alternate solution available to monitor the card Status ?

436
Views
0
Helpful
2
Replies