on 2610 if I configure MLPPP then my routing updates stops
2610 was running with ppp and eigrp protocols. Because of QoS command which are to implemented in the network for VOIP the PPP has changed to MLPPP. From that instance onwards routing updates are not taking place and the load parameter in show interface is showing very high but actually no data is flowing. I have tested with extended ping with andwithout MLPPP in first case extended ping with higher datagrams is ok and with MLPPP it is not happening.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...