cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
241
Views
0
Helpful
1
Replies

Open message error between iBGP peers

pavlosd
Level 2
Level 2

We are trying to establing an ibgp session between a Cisco 3600 series running IOS IP Plus 12.3 and an Ericsson node running Gated over VXWorks platform. We have used the following configuration as far as the cisco is consirned:

router bgp 64445

no synchronization

bgp log-neighbor-changes

neighbor 192.168.130.249 remote-as 64445

neighbor 192.168.130.249 description Gp BG to Gn1

neighbor 192.168.130.249 send-community extended

neighbor 192.168.130.249 soft-reconfiguration inbound

neighbor 192.168.130.250 remote-as 64445

neighbor 192.168.130.250 description Gp BG to Gn2

neighbor 192.168.130.250 send-community extended

neighbor 192.168.130.250 soft-reconfiguration inbound

The following erros are encountered on the VXWorks site (Gated).

Open message error code 2. Authentication failure (Sub 5).

Regards.

1 Accepted Solution

Accepted Solutions

Harold Ritter
Cisco Employee
Cisco Employee

The issue is due to the Ericsson node not complying to RFC2842 (Capabilities Advertisement with BGP-4) and therefore can't handle the capability option in the open message coming from the Cisco router properly. There is a hidden command that you can use in IOS to revert to a pre-RFC2842 behavior. This command is :

nei x.x.x.x dont-capability-negotiate.

This should solve your issue.

Hope this helps,

Harold Ritter
Sr Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México

View solution in original post

1 Reply 1

Harold Ritter
Cisco Employee
Cisco Employee

The issue is due to the Ericsson node not complying to RFC2842 (Capabilities Advertisement with BGP-4) and therefore can't handle the capability option in the open message coming from the Cisco router properly. There is a hidden command that you can use in IOS to revert to a pre-RFC2842 behavior. This command is :

nei x.x.x.x dont-capability-negotiate.

This should solve your issue.

Hope this helps,

Harold Ritter
Sr Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: