Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Openview and Cisco Routers

This is one of those things I wrote down how to do years ago, and I can't find that note now that I'm doing this again.

I'm setting up a fresh hpov system to poll and monitor a network for a customer. Does anyone know how to do the correct correlation of "Openview" ifindexes/interface numbering to Real Cisco names in the Alarm/Event log? ie: I get "Interface 1310 is exceeding threshold xxxx" or an Incorrect Serial Interface identifier... Instead of Serial4/0/4:0.16 Blah Blah Blah.

Thanks in advance

2 REPLIES
awo
New Member

Re: Openview and Cisco Routers

HP OV 6.2* support this correlation (should 8-) )

but if you have some of new IOSes try to use

snmp-server ifindex persist

command

Blue

Re: Openview and Cisco Routers

Per http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121newft/121t/121t5/dt5ifidx.htm, this command was introduced in 12.0(11)S and then integrated in 12.1(5)T.

86
Views
0
Helpful
2
Replies