I have a PRI interface on my central access server and all sites dial into it.
I cannot define ospf point-to-multipoint on the respective serial3/0:15 interface, because when I use this type of mode for ospf,the "sh ip ospf interface" command reveals state DOWN. When using point-to-point there are no problems, but i would like to user point-to-multipoint because I have multiple sites.
Re: osfp on pri interface in point-to-multipoint mode
Your only option is to use point-to-multipoint. You need to change the hello timers on the remote sites to 30 seconds because by default dialer/bri timer is 10 seconds. Or you can change the remote network type to point-to-multipoint. Please refer to the following URL for more details:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...