02-26-2002 08:52 AM - edited 03-01-2019 08:38 PM
To establish OSPF adj. in NBMA network do you need neighbour command on both sides(Hub and Spoke) or using neighbour command on hub will be enough.
amdcent
02-26-2002 01:15 PM
If I remember correctly, you do not need to specify neighbors on spokes as long as you set the OSPF priority to 0 on the spoke interface.
Mick.
02-26-2002 06:43 PM
Check this URL out
http://www.cisco.com/warp/customer/104/3.html
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: