I have an OSPF issue I'm attempting to resolve in lab. I'm using a 3640 router with two ethernet interfaces....e0/1 to 2924xl (which is representing our internal LAN) and e0/0 which I'm using two IP addresses on (one which represents the e-biz side and the other that represents the corporate internet access side of the network.
e0/0 is connected to another 2924xl (which is just being used as a passive hub and has no ip address) which then splits off to two 2611 routers representing the e-biz and internet routers.
My issue is that I can't get my 3640 to talk OSPF with it's neighbour on the SECONDARY IP address side.
I've tried using the same as well as different OSPF areas for both subnets to no avail.....
Any ideas out there would be greatly appreciated..........
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.