cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
684
Views
0
Helpful
2
Replies

OSPF betwenn 7206 and Ascend MAX

mitchel
Level 1
Level 1

I am trying to get OSPF working between my 2 Ascend MAX6000's and my 7206. Does anyone have any tips on how to make this work?

Thanks,

Mitchel

2 Replies 2

donewald
Level 6
Level 6

Mitchel,

Other than making sure your interface MTU's /ospf network-type is set the same I can think of only gathering "debug ip ospf adj" from your cisco router which might show us what is keeping your router and Ascend box from going into a full state (if this is even the issue). If you can shed somemore light on your specific issue with OSPF between the two it might help us help you.

Hope this helps you,

Don

Don, here is output from my router and the config on the Ascend MAX. A sh ip ospf neigbor shows none.I have all interfaces except fasteht set to passive. The MAX's are connected to the fasteth int via switch.

c7206#sh ip ospf 201

Routing Process "ospf 201" with ID 216.88.192.246

Supports only single TOS(TOS0) routes

Supports opaque LSA

It is an autonomous system boundary router

Redistributing External Routes from,

static, includes subnets in redistribution

SPF schedule delay 5 secs, Hold time between two SPFs 10 secs

Minimum LSA interval 5 secs. Minimum LSA arrival 1 secs

Number of external LSA 6. Checksum Sum 0x2F659

Number of opaque AS LSA 0. Checksum Sum 0x0

Number of DCbitless external and opaque AS LSA 0

Number of DoNotAge external and opaque AS LSA 0

Number of areas in this router is 1. 1 normal 0 stub 0 nssa

External flood list length 0

Area BACKBONE(0) (Inactive)

Number of interfaces in this area is 630

Area has no authentication

SPF algorithm executed 156 times

Area ranges are

Number of LSA 1. Checksum Sum 0x8DD5

Number of opaque link LSA 0. Checksum Sum 0x0

Number of DCbitless LSA 0

Number of indication LSA 0

Number of DoNotAge LSA 0

Flood list length 0

c7206#sh ip ospf interface

FastEthernet0/0 is up, line protocol is up

Internet Address 64.240.109.1/24, Area 0

Process ID 201, Router ID 216.88.192.246, Network Type BROADCAST, Cost: 1

Transmit Delay is 1 sec, State DR, Priority 10

Designated Router (ID) 216.88.192.246, Interface address 64.240.109.1

No backup designated router on this network

Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5

Hello due in 00:00:07

Index 1/1, flood queue length 0

Next 0x0(0)/0x0(0)

Last flood scan length is 2, maximum is 21

Last flood scan time is 0 msec, maximum is 4 msec

Neighbor Count is 0, Adjacent neighbor count is 0

Suppress hello for 0 neighbor(s)

c7206#sh ip ospf database

OSPF Router with ID (216.88.192.246) (Process ID 201)

Router Link States (Area 0)

Link ID ADV Router Age Seq# Checksum Link count

216.88.192.246 216.88.192.246 719 0x80001257 0x8DD5 21

Type-5 AS External Link States

Link ID ADV Router Age Seq# Checksum Tag

206.129.12.0 216.88.192.246 719 0x80000966 0x7973 0

206.129.13.0 216.88.192.246 719 0x80000966 0x6E7D 0

207.149.12.0 216.88.192.246 719 0x8000085C 0x9250 0

207.149.12.8 216.88.192.246 1741 0x8000004E 0x7854 0

209.102.32.0 216.88.192.246 719 0x8000060E 0x8B19 0

209.102.32.128 216.88.192.246 719 0x8000060E 0x78AC 0

interface FastEthernet0/0

ip address 206.129.32.1 255.255.255.0 secondary

ip address 206.129.12.1 255.255.255.240 secondary

ip address 206.129.12.17 255.255.255.248 secondary

ip address 206.129.12.33 255.255.255.224 secondary

ip address 206.129.12.65 255.255.255.224 secondary

ip address 209.102.33.1 255.255.255.0 secondary

ip address 209.129.13.1 255.255.255.0 secondary

ip address 206.129.12.193 255.255.255.192 secondary

ip address 64.240.108.1 255.255.255.0 secondary

ip address 64.240.109.1 255.255.255.0

ip route-cache flow

ip ospf network broadcast

ip ospf priority 10

half-duplex

FastEthernet0/0 is up, line protocol is up

Hardware is DEC21140A, address is 0003.e454.2000 (bia 0003.e454.2000)

Internet address is 64.240.109.1/24

MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

reliability 255/255, txload 2/255, rxload 4/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Half-duplex, 100Mb/s, 100BaseTX/FX

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters 11w3d

Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 262 drops

5 minute input rate 1935000 bits/sec, 390 packets/sec

5 minute output rate 923000 bits/sec, 331 packets/sec

3059104494 packets input, 3087473237 bytes

Received 8523693 broadcasts, 0 runts, 3 giants, 266 throttles

2527 input errors, 2526 CRC, 0 frame, 11 overrun, 69 ignored

0 watchdog

1239 input packets with dribble condition detected

2098148658 packets output, 3472816349 bytes, 1129 underruns

1351 output errors, 131650836 collisions, 26 interface resets

0 babbles, 0 late collision, 29 deferred

222 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

MAX OSPF COnfig:

RunOSPF=Yes

Area=0.0.0.0

AreaType=Normal

HelloInterval=10

DeadInterval=40

Priority=5

AuthType=None

AuthKEy=N/A

KeyId=N/A

MD5Key=N/A

Cost=1

ASE-type=N/A

ASE-Tag=N/A

TransitDelay=1

RetransmitInterval=5

OSPF Global Options:

Enable ASBR=Yes

MAX # LSA=0

Thanks ,

Mitchel