I have the following static route configuration:
my remote router is connected to:
loopback:10.178.201.254/30
10.178.202.0/24(vlan1)
10.178.203.0/24(vlan2)
serial0:10.178.222.254/30
ISDN0:10.178.222.251/30
my central router is connected to:
loopback:192.168.1.254/30
10.178.223.0/24
serial0:10.178.222.253/30
ISDN0:10.178.222.252/30
the central router has static routes to many 10.178.0.0 subnets.
I intend to use OSPF, can I put the 2 routers under area 0 for network 10.0.0.0 on both side? Should I leave the BRI interface as static, or put the ip ospf demand circuit command onto it and run OSPF as well?
Thank you.