the way OSPF communicates depends on how your network is set up. In your case, it looks like all routers are connected back-to-back with point-to-point links. OSPF uses the concept of adjacencies: an OSPF router has an adjacency with a connected router, which means that they have the exact same view of the entire network. If you do a 'show ip ospf neighbor' on your RouterA and your RouterE, it tells you the adjacencies these routers have with other connected routers. Now let's say the link between RouterA and RouterB goes down. RouterC notifies RouterD, and RouterD notifies RouterE immediately by exchanging link-state packets.
Keep in mind that on a multiaccess segment (where multiple OSPF routers are directly connected on the same segment), the concept of DR (Designated Router) and BDR (Backup Designated Router) comes into play: on a multiaccess segment, a DR and a BDR are elected, and all other routers have full adjacencies only with the DR and the BDR.
Regarding the multicast traffic: it is handled just as unicast traffic (unless you specifically block it).
Does that make sense ? If you are just starting with OSPF, have a look at the link below, which contains a pretty good introduction of the basic concepts.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.