Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

OSPF Network Range Problem

I am running some tests leading up to substantial change to our OSPF areas.

A rea 0.0.0.0 currently ranges from 10.0.0.0 to 10.31.255.255

and area 1.0.0.0 from 10.32.0.0 to 10.63.255.255 with the following commands

under ospf router:-

network 10.0.0.0 0.31.255.255 area 0.0.0.0

network 10.31.0.0 0.31.255.255 area 1.0.0.0

I want to collapse area 0.0.0.0 to the IP range 10.0.0.0 to 10.1.255.255 and

expand area 1.0.0.0 to the IP range 10.2.0.0 to 10.63.255.255.

I input the following into the test router (ios 11.3.5.t))deleted the

original statements first)

network 10.0.0.0 0.1.255.255 area 0.0.0.0

network 10.2.0.0 0.63.255.255 area 1.0.0.0

When I do "sh run" the statements look like this:-

network 10.0.0.0 0.1.255.255 area 0.0.0.0

network 10.0.0.0 0.63.255.255 area 1.0.0.0

Area 1.0.0.0 seems to extend from 10.0.0.0 to 10.63.255.255 clashing with

area 0.0.0.0? Connected interfaces though seem to get put into the correct

area when I do "sh ip ospf int"

Any ideas? are my statements correct to achieve the objective?

1 REPLY
New Member

Re: OSPF Network Range Problem

If you look at the conversation "OSPF Connected networks " in this forum, last updated 2nd July, you'll find the answer to this.

121
Views
0
Helpful
1
Replies
CreatePlease login to create content