Soon I will be using OSPF as routing protocol. We have configured Fastethernet sub-interfaces and using HSRP between the two routers. In serial interface I have defined the priority to make DR and BDR, so just wanted to know do I have to assign the priority for all the FastEthernet sub-interfaces so I can control which router becomes DR and BDR for particular segment or is there any other way to increase the priority of all the Fastethernet interfaces.
Why are you concerned about which router is dr and bdr in this situation? The priority will only help with initial convergence, so you might not end up with the "right" router dr and bdr anyway, even when setting the priority. A higher priority router will not "bump" a lower priority router from being dr when it comes on the link.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.