Not sure if this is the answer you are looking for but you can always explicitly configure the OSPF network type on your interfaces such that there is no DR/BDR election. Obviously this would result in the DR/BDR RID being 0.0.0.0. Good luck
Thank you for your reply, but what i am looking is a way to make in a hub and spoke topology that the RID of DR/BDR is 0.0.0.0, without changing the ospf network type to point-to-point or point-to-multipoint.
Why would you want the router id of a router to be 0/0? We would accept this for a while, but we've recently changed it so we won't accept it any longer. Are you trying to make the hub always be the DR/BDR? If so, then you really want to use the ospf priority, not the router id.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...