I want to setup a test environment so I can play with OSPF configuration before I attempt anything on the production network. Can anyone suggest the minimum number/type of devices and the interface connections needed for this? Here is a list of devices I have to use. I may need to buy some serial DTE/DCE cables to link serial interfaces together (if needed, not sure).
Cisco 2610 - SE0/0, Ethernet0/0, BRI0/0
Cisco 2501 - (2)Serial, AUI
Cisco 2502 - (2)Serial, TokenRing
Cisco 805 - Serial0, Ethernet0
Cisco WS-2820 - two of these
Perhaps the more I can connect, the better the environment??? Any suggestions would be appreciated.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...