Are you familiar enabling ospf on a router. ??? The 6509 switch (layer 2)cannot run OSPF. THe MSFC on the 6509 can run OSPF, which is a router by itself. Syntax for enabling OSPF are same as the normal Cisco routers.
To access the MSFC console, you can either directly console in, or go in through the switch.
Switch(console)#show module, will tell you which slot the MSFC is in.
Switch(console)#session where module no is the slot no for MSFC which you get from MSFC.
This will give you access to the MSFC (the console is exactly the same as an ordinary external router).
Now you can enable ospf...Search for OSPF guide at ,
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...