Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

ospf

hello

suppose i have a hub and spoke architecture:

the HUB router is connected to remote sites by:

LL (PPP) rate= 33,6Kbps &

FR (sub-interfaces point-to-point) 64Kbps.

i use ospf for routing (1 area: area 0)

-1. i think i don't need to configure neighbours (for ospf) because i use subinterfaces as point-to-point. am'i right?

-2.can i configure the routers to loadbalance trafic between LL & FR ?

thanks

1 REPLY
Bronze

Re: ospf

1. You are correct, you do not need to configure neighbors.

2. OSPF will load balance provided that the LL interface and the FR sub-interface to a location each have the same cost. You can make them have the same cost via the bandwidth interface command or the ip ospf cost interface command.

HTH

Mark

81
Views
0
Helpful
1
Replies
CreatePlease to create content