01-08-2002 12:04 AM - edited 03-01-2019 07:57 PM
My Catalyst with 2 supervisors give this message:
Catalyst6506> (enable) 2002 Jan 08 08:47:45 %SYS-5-MOD_OK:Module 15 is online
2002 Jan 08 08:47:47 %SYS-5-MOD_NOSCPPINGRESPONSE:Module 16 not responding... re
setting module
2002 Jan 08 08:47:47 %SYS-5-MOD_RESET:Module 16 reset from Software
And then when I type show module, it display this:
Catalyst6506> (enable) show module
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1 1 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes standby
15 1 1 Multilayer Switch Feature WS-F6K-MSFC2 no ok
2 2 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes ok
16 2 1 Multilayer Switch Feature WS-F6K-MSFC2 no other
3 3 16 1000BaseX Ethernet WS-X6416-GBIC no ok
4 4 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok
I would like upgrade with 12.1.8b.E7 but I found the boot but not the IOS image.
Can anybody tell me the names of the versions that I have to put in.
Thanks a lot
01-09-2002 12:02 AM
It the status is "other", it means the switch can recognize the module. But can't init it. I also have such experience.
Most likely, you should open a TAC case in cisco and let TAC engineer handle it. In my case, it is RMA.
01-10-2002 05:29 PM
MSFC needs two images. Boot image is the "helper" image but you need to download regular image like
c6msfc2-jsv-mz
and change the boot variable to load the image
boot system flash bootflash:
boot bootldr bootflash:
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: