Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Output Drops - ATM

Hi

I am experiencing output drops on my ATM. The load is around 50 %. Any suggestion why this occur?

Output from a show interface ATM 2/0

ATM2/0 is up, line protocol is up

Hardware is ENHANCED ATM PA

MTU 4470 bytes, sub MTU 4470, BW 7000 Kbit, DLY 80 usec,

reliability 255/255, txload 85/255, rxload 111/255

Encapsulation ATM, loopback not set

Keepalive not supported

Encapsulation(s): AAL5

4096 maximum active VCs, 1 current VCCs

VC idle disconnect time: 300 seconds

0 carrier transitions

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters 03:31:27

Input queue: 0/390/0/0 (size/max/drops/flushes); Total output drops: 205254

Queueing strategy: Per VC Queueing

30 second input rate 3050000 bits/sec, 1703 packets/sec

30 second output rate 2355000 bits/sec, 1689 packets/sec

22393410 packets input, 1127164926 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

22954714 packets output, 273226211 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

1 REPLY
New Member

Re: Output Drops - ATM

85
Views
0
Helpful
1
Replies
CreatePlease to create content