Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Output of show int po1 etherchannel doesnt show load?

Hi,

I have a set of 3750 switches which are stacked into 2 sets of 3. I have creted a port channel on each stack that connects to the other stack, as it is cross stack I have used channel-mode on. when i type the follwoing command, some values show as zero, is this a bug, or just not supported?

show interface po1 ether

Age of the Port-channel = 18d:03h:58min:11s

Logical slot/port = 10/1 Number of Ports = 3

GC = 0x00000000 HotStandBy port = null

Port state = Port-channel Ag-Inuse

Protocol = -

Ports in the Port-channel:

Index Load Port EC State No of bits

------+------+------+-------------------+---------

0 00 Gi1/0/28 On/FEC 0

0 00 Gi2/0/28 On/FEC 0

0 00 Gi3/0/28 On/FEC 0

Shouldnt I see the Load entries and bits entries change from 0?

2 REPLIES
Bronze

Re: Output of show int po1 etherchannel doesnt show load?

New Member

Re: Output of show int po1 etherchannel doesnt show load?

Beth-martin,

the link doesnt seem to work is thee=re case number you can advise so I can review thsi further?

many thanks!

414
Views
0
Helpful
2
Replies
CreatePlease to create content