11-27-2003 08:04 PM - edited 03-02-2019 12:01 PM
Hello,
I found the packet loss issue when 2950 switch connect to 3Com Netbuilder II router directly. Any knows what is the cause?
The temporary workaround I using is add a hub in the middle to fix the problem.
Regards,
Bennith.
11-27-2003 08:34 PM
Pls check the Netbuilder side setttings of the interface.
Wether it supports 100Mb.
Also check duplex settings, if it is 10Mb, halfduplex
set the same at switch side, which should solve the problem.(default at switch side autonegotiation)
11-27-2003 10:15 PM
Found the cause:-
1. 3Com 10Mbps module(AUI/BNC) + AUI Transceiver cause the speed negoication problem.
Now we use the 100Mbps module(RJ45) to fix the problem,
Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: