Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

packet was less than 2 bytes

We have a router 2621 (MPC860) on which runs the ios 12.0(4). When connection Isdn BRI is activated, we have this message:"%pquicc-1-toosmall: pquicc[0/0], packet was less than 2 bytes"

what does that mean? and if it is a problem, is there a solution?

Thank you

  • Other Network Infrastructure Subjects
2 REPLIES
New Member

Re: packet was less than 2 bytes

Saw this recently on a customer's 2620. Tied up to bug CSCdw90765 or CSCds51025. Resolved by upgrade to 12.2(12).

Hope this helps.

New Member

Re: packet was less than 2 bytes

Make sure that you have all the requirements to connect to ISDN BRI, for your router 2621 you may purchase network module (NM-4B-U) for four-port ISDN BRI or NM-8B-U for 8-port module. Don't forget to assign switch-type for your connection, ask your provider to get correct switch-type, without this correct switch-type you may experience wierd error command. Also make sure you assign correct SPIDs, again get this number from your provider. Hope can help..

87
Views
0
Helpful
2
Replies
This widget could not be displayed.