cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
374
Views
0
Helpful
1
Replies

PAD configuration

i-diallo
Level 1
Level 1

Hi

I have a asynchrone line with a TPE ( Terminal of Payement Electronic ) to connect to a X25 server .

I use a cisco router (C2500 ) and US robotic Modem

the serial S0 is directly connect to server and is a DCE ,the one asynchrone serial is connect to the modem .

If i use my laptop and i call the modem

" ATDT 431086 " I am connected to the PAD and I can to connect to server

" call 400000006 "

and i am connected .

but if I use the TPE the connexion is fail

My remark is if i call the remote modem with my laptop i must put ENTER for the connexion establish

and the * of the PAD is displyed

can you help for this connexion

1 Reply 1

amritpatek
Level 6
Level 6

You can use some of the modem/x25 related debug commands on the router to check for successful and failure calls. That might give you some clue.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: