Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PAD Interface

Is it possible on a NM-4A/S to configure a PAD (packet assembler/disassembler) interface?

And if it is possible, how?

Thanks

1 REPLY
Silver

Re: PAD Interface

PAD functionality is supported on all Async lines, the following URL is the PAD config guide

http://www.cisco.com/en/US/customer/products/sw/iosswrel/ps1828/products_configuration_guide_chapter09186a0080087255.html

77
Views
0
Helpful
1
Replies
CreatePlease to create content