Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

pad over routers aux port

hi,

we want to connect a kreditcardterminal over pad to the routers aux-interface.

but the first problem is that we do not know which cable to use.

there is also a rj45 connector on the terminal

should we use a rolled-cable, straight through,...??

is there a comman on the router, where i can see that the aux is "up" - like a syncron-serial routerinterface ?

what about dte/dce - is the routers aux a dce ??

which pin is what signal on the aux ??

fact is, that when we connect that terminal to a other x25 switch, everything is fine.

if we connect this terminal to routers aux, nothing works - not even a pad/x25 call !!

any idea - please help

1 REPLY
Bronze

Re: pad over routers aux port

Since the AUX port only provides a terminal connection or an encapsulation like PPP, SLIP and BSTUN , I don't think you can connect to it using a PAD connection. You must be able to get the port and pinout details from the documentation for the device that you are using and the following link :

http://www.cisco.com/en/US/products/hw/accessor/ps107/products_tech_note09186a0080094ce6.shtml

86
Views
0
Helpful
1
Replies