Hi, I have a Linksys PAP2 phone adapter with V3 stamped on the circuit board. After upgrading the firmware the red power LED's are now blinking erratically, apparently in SOS mode .. 3 short, 2 long, 3 short. My router is not assigning it an IP address and there is no dial tone in IPV. Do you happen to have some sort of recovery tool that might bring this unit back to life? Any help is very appreciated!
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...