We have a Paradyne 9580 that is converting from an MCI ATM network to frame-relay on a Cisco 7200 Hssi port. The other end connects the MCI ATM network directly into a native ATM card on another 7200 (PA-A3 card).
The Paradyne is using 'transparent' mode, and from what I have read on Cisco web, when using this mode for internetworking, we should use frame-r encapsulation of ietf, and atm encap of aal5nlpid.
Will this work? Currently, we have atm encap of aal5snap configured, and I can't ping either side. Also, will this atm encap allow for full ip routing tables to be passed between routers?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...