Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Partition on 4500

I have a 4500 router with this setting. I like to delete partition and make it one. Is it doable on 4500 series router? Here is the Sh Ver:

Hurd_R1#sh v

00:02:52: %SYS-5-CONFIG_I: Configured from console by console

Hurd_R1#sh ver

Cisco Internetwork Operating System Software

IOS (tm) 4500 Software (C4500-IS-M), Version 11.3(11a), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-1999 by cisco Systems, Inc.

Compiled Mon 20-Sep-99 17:02 by jjgreen

Image text-base: 0x60008930, data-base: 0x60780000

ROM: System Bootstrap, Version 5.3(16) [richardd 16], RELEASE SOFTWARE (fc1)

BOOTFLASH: 4500 Software (C4500-BOOT-M), Version 11.1(7), RELEASE SOFTWARE (fc2)

Hurd_R1 uptime is 2 minutes

System restarted by power-on

System image file is "flash:c4500-is-mz.113-11a.bin", booted via flash

cisco 4500 (R4K) processor (revision E) with 16384K/4096K bytes of memory.

Processor board ID 06450824

R4700 processor, Implementation 33, Revision 1.0

G.703/E1 software, Version 1.0.

Bridging software.

X.25 software, Version 3.0.0.

Basic Rate ISDN software, Version 1.0.

2 Ethernet/IEEE 802.3 interface(s)

4 Serial network interface(s)

4 ISDN Basic Rate interface(s)

128K bytes of non-volatile configuration memory.

4096K bytes of processor board System flash partition 1 (Read/Write)

4096K bytes of processor board System flash partition 2 (Read/Write)

4096K bytes of processor board Boot flash (Read/W)

Looks like the total Flash I have is 12MB, and want to make it to one so I can install the 12.1 IOS which requries atleast 8MB of Flash. I also opened the box and it had 3 chips each containing 4MB, I guess.

Regards,

2 REPLIES

Re: Partition on 4500

The "no partition flash" command should help in removing the partitions.

Silver

Re: Partition on 4500

no this is not possible you have 2 4 MB simms If you partition the flash you must partition it as 2 4 MB partitions. The other 4 MB is bootflash you can not combine this with the flash partitions. In order to fit 12.1 code you must upgrade your flash simms

Also you only have16 MB of DRAM you may want to check the DRAM requirements

128
Views
0
Helpful
2
Replies
CreatePlease to create content