I have a 2503 router that has 2 4-MB flash SIMMs installed. These exist as 2 seperate 4-MB partitions if I look at the flash config. I need to upgrade my IOS which presently is contained on the first flash SIMM. The lastest file is 5.6MB insize. Is it possible to create a single flash partition from these 2 seperate physical flash SIMM's so that I can upgrade to the new 5.6 MB image file, or do I need a memory upgrade to support it.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...