04-27-2006 12:33 PM - edited 03-03-2019 02:59 AM
Is it possible to define passive interface for all interfaces on 4510R switch except the ones connected to routers, so that I don´t have RIP protocol passing through the LAN?
04-27-2006 12:48 PM
Not sure about rip but for all other protocols under the routing protocol just issue the command "passive-interface default" and then just do a "no passive-interface slot/port" for the interfaces you want to run the protocol on.
04-27-2006 04:08 PM
Hello Marcia,
you could try to do a:
4510R#conf t
4510R#(config)router rip
4510R#(config-router)#passive-interface default
If the command is there, then you'll are good to go!
HTH,
I'd appreciate if you rate this post if it helps.
Vlad
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide