Password recovery on 6500 MFSC2 running 12.1(13)E3
Configuring MfSC2 on new switch, saved config and reset module, enable password not being taken. Break sequence not working, tried all in list with no luck, anyone have a break sequence that works on W2K platform?
Re: Password recovery on 6500 MFSC2 running 12.1(13)E3
I have followed both of these procedures even the simulation of the break sequence and the router just goes right back to the router prompt not rommon. If there is a way to just blow it all out that would work for now, I can restore the config.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...