Changing the config register to 0x2142 will allow you to do password recovery and still keep your old config, although it will not be loaded into running. If you get the router up with the config register change and do a "copy start run" you'll be back to where you left off. Just don't do a "write mem" before this copy is done. Ensure you change your password to what you want it to be before getting out of enable mode, also admin up your interfaces.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...