Changing the config register to 0x2142 will allow you to do password recovery and still keep your old config, although it will not be loaded into running. If you get the router up with the config register change and do a "copy start run" you'll be back to where you left off. Just don't do a "write mem" before this copy is done. Ensure you change your password to what you want it to be before getting out of enable mode, also admin up your interfaces.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...