Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PAT HELP

I sent a message before for the following

Serial 0/0 200.200.200.200

eth 0/0 10.10.10.1

eth 0/1 201.201.201.201

ip nat inside source list 1 interface Serial0/0 overload

so the 10.10.10.0 net is nat'd to 200.200.200.200

what i would like to do is

telnet 200.200.200.200:100 and PAT to 201.201.201.204:21

someone suggested

ip nat inside source static 200.200.200.200 100 201.201.201.204 21

this does not work!

it will not allow he port

any hel available?

j

2 REPLIES
Silver

Re: PAT HELP

I think that you're just missing the tcp key word in your translation.

ip nat inside source static tcp 200.200.200.200 100 201.201.201.204 21

NOTE 21 is an FTP port not telnet (23)... FYI

Hope that helps,

Don

Silver

Re: PAT HELP

Did you try the tcp key word?

ip nat inside source static tcp 200.200.200.200 100 201.201.201.204 21

Hope this helps,

Don

77
Views
0
Helpful
2
Replies