Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

patch cord length between two C2950SX-24

hello,

I want to connect two C2950SX-24 that are located in the same cabinet, by their 1000BASE-SX MT-RJ port, does the fiber patch cord must have a minimum length ?

regards

2 REPLIES
Gold

Re: patch cord length between two C2950SX-24

The minimum patch cable length for all the 1000BASE-X optical GBICs whether multimode fiber or single-mode fiber is 2 meters.

I would assume that it is the same minimum for the built-in 1000BASE-SX ports with MT-RJ connectors.

Hope this helps.

New Member

Re: patch cord length between two C2950SX-24

I’m trying to connect a Catalyst 6513 to a Catalyst 2950 using its MT-RJ ports but the switches didn’t link with each other.

I would like to know if you could connect your switches successfully using its MT-RJ ports and which kind of fiber did you use.

Thanks, Thiago

87
Views
0
Helpful
2
Replies
CreatePlease to create content