Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

pb AS2511

I have this error message when i try to configure the AS2511 for the first time :

"can't find master interface for async IP support" and the setup program stops.

It is a hardware problem ?

1 REPLY
Silver

Re: pb AS2511

This will happen when setup (config maker) tries to configure the async interfaces, and there is no ip address on the ethernet of the router.

As a workaround, on the initial pass through setup, answer "no" to the

question about configuring the async interfaces. This will allow the basic

ethernet/ip configuration to entered. Once the router is "up" in that mode,

enter the setup command again (manually) and answer "yes" for the async

interfaces, and it should work.

Just curious, what IOS image do we have on the 2511 (maybe you have not even reached where you can get this info)...this issue was seen on 11.3 images, CSCdk20935.

Thanks, Mak.

81
Views
0
Helpful
1
Replies
CreatePlease to create content