I have a route-map setup on a port to route only internet traffic to the next-hop. I would like to be able to route-map one of the ip's on the network that is being routed to a different next-hop. Here is my config:
ip access-list extended inet
deny ip any 192.168.0.0 0.255.255.255 (this is the network accessing the internet)
deny ip any 10.50.1.0 0.255.255.255 (this is the network on my switches)
deny ip any 10.51.3.0 0.255.255.255 (this is the network with different gateways to the internet)
permit ip any any
route-map dsl01 permit 10
match ip address inet
set ip next-hop 10.51.3.2
So the route-map is assigned to port 5 on the switch and it routes internet traffic to 10.51.3.2. But I would like to be able to route just machine 192.168.0.1 to a different hop (10.51.3.3). Can this be done in the route-map or acl?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...