I have a route-map setup on a port to route only internet traffic to the next-hop. I would like to be able to route-map one of the ip's on the network that is being routed to a different next-hop. Here is my config:
ip access-list extended inet
deny ip any 192.168.0.0 0.255.255.255 (this is the network accessing the internet)
deny ip any 10.50.1.0 0.255.255.255 (this is the network on my switches)
deny ip any 10.51.3.0 0.255.255.255 (this is the network with different gateways to the internet)
permit ip any any
route-map dsl01 permit 10
match ip address inet
set ip next-hop 10.51.3.2
So the route-map is assigned to port 5 on the switch and it routes internet traffic to 10.51.3.2. But I would like to be able to route just machine 192.168.0.1 to a different hop (10.51.3.3). Can this be done in the route-map or acl?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...