Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

PBR with non-connected next hop

I am trying to set 'ip next-hop' to a non-connected ip address but it doesn't work I expected it. I remember reading somewhere that it will do a routing lookup for the non-connected address. Is it related a specific code version? Any advise??

Thanks,

Mannan

CCIE # 8906

1 REPLY
Bronze

Re: PBR with non-connected next hop

That configuration doesn't work. The ip next-hop must point to a connected address. I believe the documentation you read was incorrect.

86
Views
0
Helpful
1
Replies
CreatePlease to create content