Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Perform CLI and dial back on that number

Hi everyone,

I am looking into setting up the following scenario using some 2640s:

I would like my client site to dial my HQ site and then drop the call; following that I need the HQ site to pick up the phone number that dialled it and use it to dial back into the client site.

Up to now I use static tables with telephone numbers; is there a way to automaticaly set this up from the CLI of the BRI?

Many thanks,

George

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Perform CLI and dial back on that number

YES..You need to configure callback based on CallerID.. Here are some good urls for sample config and troubleshooting.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_c/dccallid.htm

http://www.cisco.com/warp/public/793/access_dial/Isdn_callerID.html

1 REPLY
Cisco Employee

Re: Perform CLI and dial back on that number

YES..You need to configure callback based on CallerID.. Here are some good urls for sample config and troubleshooting.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_c/dccallid.htm

http://www.cisco.com/warp/public/793/access_dial/Isdn_callerID.html

85
Views
0
Helpful
1
Replies