Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

PIM DR and IGMP Querier - Can you hard set?

Hello, can I set the HSRP active interface to be the IGMP and PIM active interfaces rather that using the highest (PIM) and lowest (IGMP) IP addresses to set the active?

Many thx

Vlan205 is up, line protocol is up

Internet address is 1.1.1.252/16

IGMP is enabled on interface

Current IGMP host version is 2

Current IGMP router version is 2

IGMP query interval is 60 seconds

IGMP querier timeout is 120 seconds

IGMP max query response time is 10 seconds

Last member query response interval is 1000 ms

Inbound IGMP access group is not set

IGMP activity: 0 joins, 0 leaves

Multicast routing is enabled on interface

Multicast TTL threshold is 0

Multicast designated router (DR) is 1.1.1.252 (this system)

IGMP querying router is 1.1.1.251

No multicast groups joined

1 REPLY
Bronze

Re: PIM DR and IGMP Querier - Can you hard set?

You could always force a interface to be an active HSRP interface by configuring the appropriate HSRP commands.

294
Views
0
Helpful
1
Replies
CreatePlease to create content